Edmonton Zoning Bylaw 12800

970.8  (EETL) Edmonton Energy and Technology Park Logistics Zone

1.          General Purpose

The purpose of this Zone is to provide opportunity for the development of logistic hubs within the Edmonton Energy and Technology Park Area Structure Plan area to support the petrochemical cluster precinct as well as the manufacturing segments as defined in the Edmonton Energy and Technology Park. Commercial uses are to be located along the periphery of the precinct as defined in the Edmonton Energy and Technology Park Area Structure Plan and adjacent to highways, arterial or collector roads.

2.          Permitted Uses

  1. Convenience Retail Stores

  2. Equipment Rentals

  3. General Industrial Uses

  4. Industrial Logistics

  5. Minor Impact Utility Services

Charter Bylaw 18613

November 26, 2018

  1. Special Event

  2. Special Industrial Uses

  3. Specialty Food Services

  4. Fascia On-premise Signs

  5. Freestanding On-Premise Signs

3.          Discretionary Uses

  1. Automotive and Equipment Repair Shops

  2. Drive-in Food Services

  3. Major Service Stations

Charter Bylaw 18613

November 26, 2018

  1. Market

  2. Mobile Catering Food Services

  3. Protective and Emergency Services

  4. Restaurants

Bylaw 17901

March 6, 2017

  1. Urban Gardens

Bylaw 17901

March 6, 2017

  1. Urban Indoor Farms

Bylaw 17901

March 6, 2017

  1. Urban Outdoor Farms

  2. Vehicle and Equipment Sales/Rentals

  3. Major Digital Signs

  4. Major Digital Off-premises Signs

  5. Minor Digital On-premises Signs

  6. Minor Digital On-premises Off-premises Signs

  7. Roof On-premises Signs

4.          Development Regulations

  1. All Uses and activities, except those noted in clauses (b) and (c) below, shall be located and carried on within an enclosed building where feasible.

  2. All loading, service, trash collection and Accessory storage areas, and trucking yards shall be located to the rear or sides of the principal building, and shall be screened from view from any public roadway other than a Lane.

  3. Any site that Abuts a Residential Zone shall be screened by a 6 m berm, the berm shall be landscaped with a combination of trees and shrubs to provide additional screening and interest, this landscaping shall be to the satisfaction of the Development Officer.

  4. The Development Officer may require that exposed projections outside the building such as mechanical and electrical equipment, transformer ducts, cooling towers and materials handling equipment be screened from view from any public roadway other than a Lane, and from adjacent Sites if such projections are inconsistent with the character and appearance of surrounding development or the intended visual qualities of this Zone.

  5. Rail and pipelines may be used where applicable to reduce roadway congestion, transportation costs, and greenhouse gas emissions.

  6. The maximum Floor Area Ratio shall be 1.5.

Bylaw 17832

November 28, 2016

Bylaw 18305

February 26, 2018

Effective Date: May 1, 2018

  1. The maximum Height shall not exceed 14.0 m, except that the Development Officer may, notwithstanding Section 11.4, grant a variance to permit a greater Height for a building housing a General Industrial Use or Special Industrial Use up to a maximum of 18.0 m, where this is required to facilitate the industrial development of the Use involved.

  2. The Front setback shall be 3.0m where the Front Lot Line of a Site Abuts a public road other than arterial, service or collector road and 6 m in all other cases.

  3. Commercial Uses shall only be located:

    1. On a Site Abutting a highway, arterial, service or collector road; and

    2. On a Corner Site; or

    3. On a Site where a minimum of one side lot line Abuts an existing commercial use.